Engine Components | इंजन घटक
START QUIZ पर क्लिक करें और अपना Test पूरा करें
Q1. What is the name of the piston?
Q2. What is the name of the part marked as ‘X’?
Q3. What is the speed ratio cam shaft to crank shaft?
Q4. What is the name of the piston?
Q5. What is the name of the part marked as ‘X’?
Q6. What is the reason for corrosion of bearing?
Q7. What is the purpose of the fly wheel timing mark?
Q8. What is the material for cam shaft?
Q9. What is the type of hardening done on crank shaft?
Q10. What is the cause for uneven wear of bearings?
Q11. What is the material of piston pins?
Q12. Which is the most preferred use of taper roller bearings?
Q13. Which is the load taken by the roller bearing?
Q14. Which is the most preferred use of roller bearings?
Q15. Which is the key element in converting reciprocating motion in to rotary motion?
Q16. What is the name of the part marked as ‘X’?
Q17. What is the property allows a bearing to with stand impact load for a reasonable time?
Q18. What is the name of the bearing?
Q19. What type of bearing fitted in the connecting rod big end?
Q20. Which measuring instrument used to check the fly wheel face out?
Q21. Where the fly wheel is fitted in the engine?
Q22. What is the name of the part marked as ‘X’?
Q23. What is the name of the part marked as ‘X’?
Q24. Which gauge used to measure the cylinder bore wearness?
Q25. What is the name of the part marked as ‘X’?
Q26. What is the name of part marked as ‘X’?
Q27. What is the name of the part marked as ‘X’?
Q28. What is the name of the part marked as ‘X’?
Q29. What is ovality of a crank shaft?
Q30. Which is the bearing used in water pump?
Q31. Which instrument is used to check the vacuum of the cylinder?
Q32. Which is connected with piston through piston pin?
Q33. What is the name of the tool hold by hand?
Q34. What is the name of the part marked ‘x’?
Q35. What is the name of the part marked as ‘X’?
Q36. What is the name of the piston head?
Q37. What is the name of the part marked as ‘ X’?
Q38. What is the name of the part marked as ‘X’?
Q39. What is the cause of excessive loading?
Q40.Where is the compression ring is fitted in the piston?
Q41. What is the name of the part marked as ‘x’?
Q42. What is the property of a bearing helps to with stand metal to metal contact?
Q43. What is the purpose of the timing chain?
Q44. What is the name of the tool?
Q45. What is the name of the part marked as ‘x’?
Q45. What is the name of the piston head?
Q47. What is the name of the bearing?
Q48. Which tool is required to remove the valves?
Q49. What is the load taken by taper roller bearing?
Q50. What is the material of cylinder block?
Mechanic Motor Vehicle 1st Year Module 7 Engine Components
You got {{userScore}} out of {{maxScore}} correct
{{title}}
{{image}}
{{content}}